Download PASSEMALL Prep app now
Scan QR code or get instant email to install app
Question:
Comments
Your email address will not be published. Required fields are marked *
Comment *
Name*
Email*
URL
Save my name, email, and website in this browser for the next time I comment.
Of the following conditions, when should the oil sample be taken from the refrigeration system?
When the compressor has burned out
Hermetic compressors shouldn’t be energized under vacuum because ________.
It may cause compressor burnout
Of the following conditions, when should the reciprocating compressor not be energized?
When the discharge service valve is close
What is a measuring unit of deep vacuum in a system?
Microns
The leak check should be done on heat pump that uses R-410A with _______
_______
Pressurised nitrogen
The compressor should be isolated before changing the compressor on a system containing R-410A. Then evacuate the compressor section to _______ and hold. If the system pressure does not rise, remove the compressor.
Atmospheric pressure
The primary water source most often used for cooling the condenser of a water-cooled recovery unit is _____.
local municipal water supply.
System-dependent recovery equipment CANNOT be used when _____.
the appliance contains over 15 pounds of refrigerant.
The component directly following the evaporator of the refrigeration system is the ______________
Accumulator
What is the non-operating pressure inside a R-410 refrigerant system at room temperature 72 degrees F?
210 psig
The R-12 refrigeration system which uses water cooled condenser should be charged first with vapor pressure of at least _______ before switching to liquid charging.
35 psig
Comments