Download PASSEMALL Prep app now
Scan QR code or get instant email to install app
Question:
Comments
Your email address will not be published. Required fields are marked *
Comment *
Name*
Email*
URL
Save my name, email, and website in this browser for the next time I comment.
The operating temperature of fire damper actuating device shall be approximately _____ above the normal temperature within the duct system
50°F
Supply air to a swimming pool and associated deck areas shall not be recirculated unless such air is dehumidified to maintain the relative humidity of the area at _____ or less:
60%
Ducts shall be supported with approved hangers at intervals not exceeding _____ :
10 feet
Venting systems shall be designed and constructed so as to develop a ______ flow adequate to convey all combustion products to the outside atmosphere:
Positive
Where ducts used for cooling are externally insulated, the insulation shall be covered with a vapor retarder having a maximum permeance of ______ perm:
0.05
The termination of chimneys or vents of mechanical draft systems equipped with power exhausters shall be located a minimum of ______ from the lot line or from adjacent buildings:
For a 300 ampere electrical circuit, what is the minimum size copper equipment grounding conductor as per NEC?
4 AWG
Smoke detectors shall be installed in return air systems with a design capacity greater than _______ , in the return air duct or plenum upstream of any filters:
2,000 cfm
Ferrous fan blades shall only be used for fans located within the ductwork and through which hazardous materials are exhausted.
False
If two 4 ohm resistors are connected in series which are powered by 240 volts power source, what is the current flow across one 4 ohm resistor?
30 amperes
Smoke dampers are not required in corridor penetrations where the duct is constructed of steel not less than _____ in thickness and there are no openings serving the corridor:
0.019 inch
Ozone cabinets and ozone gas-generator rooms for systems having a maximum ozone generating capacity of 1/2 pound (0.23 kg) or more over a 24-hour period shall be mechanically ventilated at a rate of not less than ______ air changes per hour:
6
The pressure classification of ducts shall equal or ______ the design pressure of the air distribution in which the ducts are utilized:
greater than
When an electrical circuit tested with ohmmeter, a short circuit is indicated by a reading of _______
_______
Zero
Comments